Micro Motion RFT9709 Manual de instrucciones descargar pdf (Pagina 39)

Using ProLink

Software with Micro Motion

Transmitters

Getting Started

continued

Exit

File Menu: Print File Menu: Log Files View Menu: VariablesBefore You Begin Getting Started File Menu: Database

• With the ProLink software configured for Modbus protocol,

choose Modbus ASCII or Modbus RTU.

If Modbus RTU (default) is chosen, the ProLink program will

use the RTU data transmission mode (8 data bits).

If Modbus ASCII is chosen, the ProLink program will use the

ASCII data transmission mode (7 data bits). Choose this

option if the communication network cannot support binary

data.

11.For Windows 3.1 users only, Time Source shows whether the

ProLink software will use a real time clock or interval timer. The time

source cannot be changed from the Configure Communications

dialog box, but must be configured in the ProLink setup routine.

Follow steps 1 through 3 to change the time source configuration.

12.Use the Parity and Stop Bits option buttons to select the appropriate

parity and stop bits.

• Under HART protocol, the transmitter must use odd parity and

one stop bit.

• Under Modbus protocol, the transmitter can use odd parity, even

parity, or no parity, and either one or two stop bits.

13.Click OK when ready to accept the software communications

configuration.

2.9 Exit

To exit the ProLink program, open the File menu, then choose Exit. The

Exit ProLink dialog box appears, as shown below.

• Select Yes to save the ProLink setup and communication options to

the PROLINK.INI file in the ProLink directory.

• Select No to exit without saving the ProLink setup and

communication options.

• Select Cancel to return to the ProLink program.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 213 214

Sin comentarios

Micro Motion RFT9709 Manual de instrucciones Pagina 39